4 WAY IMPULSE MOVEMENT FOR EXTERIOR DIALS UP TO 2000mm

Our standard four way drive unit for clocks with four dials up to 2 metres in diameter.

We typically use these movements in tower clocks in conjunction with motion work and a master clock.

• 1 minute mains impulse and suitable for dials up to 200cm in diameter.
• Driven by a 3-wire system.
• Shafts are made of stainless steel, just like all our exterior slave units.
• The standard sealing of the housing is IP52 so protected from limited dust ingress and protected from water spray less than 15 degrees from vertical.
• Fitted with a fork drive system. This prevents the wind loads on the hands from transferring onto the motor.
• Minute drive only.
• Supplied without couplings or motion work.
• Made in Belgium to the very highest standards.

The dial’s maximum diameter mentioned is indicative only and depends on:
- The wind load on the hands.
- The shape and weight of the hands.
- Whether or not the hands are balanced or not. If you use your own hands, it is very important that they are balanced.

This movement requires a GM2 (or equivalent) to operate.

These unit are built to order. Please allow up to 6 weeks for delivery.

If you are looking for a unit to drive a larger clock, even a much larger clock, then we can help you.
Variations also available with 1, 2 or 3 outputs.
Let us know you specification and we'll present you with a solution.

Equally, if you are look into this as part of a refurbishment project then do please give us a shout. We have plenty of experience and knowledge to share with you.